Five channel cable protector ramp for heavy cable and hose runs

Large temporary power and data set-ups quickly run out of channels. When you are feeding a stage, an exhibition stand, an outdoor event or a busy loading bay, five separate lines crossing a trafficked floor need to be protected, separated and clearly marked. This five channel cable protector ramp does that in a single unit: five internal channels enclose your cables and hoses, a high-visibility yellow lid warns approaching traffic, and a heavy rubber body carries the weight of vehicles crossing over the top. It is built for repeated use where a three channel ramp simply does not have enough capacity.

Why it works

The ramp is moulded from heavy duty rubber with anti-slip ramped sides, giving wheels and feet grip on the approach and exit. Five parallel channels keep each cable or hose supported and separate, which keeps a mixed run of power and data tidy and makes it straightforward to pull one line without disturbing the others. The high-visibility yellow top is the safety feature that earns its place: it gives drivers and pedestrians a clear visual cue to slow and step over, reducing the chance of a trip or a snagged cable. With a stated 6 tonne load capacity the ramp handles regular crossings by vans, pallet trucks and light plant. Interlocking ends let you join units to bridge a wider route, so one product covers a single doorway or a long cable crossing.

Where it is used

Common settings include outdoor events and festivals, concert and stage set-ups, film and broadcast locations, exhibition and conference venues, warehouse and distribution doorways, and construction site power and welfare runs. It suits any temporary or semi-permanent crossing where several cables meet a trafficked surface.

Specifications

Choosing the right option

Pick the channel count to match the number of lines you cross most often, with a little room to spare. Five channels at 50mm x 36mm suit a mix of standard power and data cables and smaller hoses; measure your largest cable and connector before ordering so each line seats and the lid closes cleanly. If you only ever run three or fewer cables, a three channel ramp is more compact and lower cost. If your crossings are by heavy plant, check that the 6 tonne rating covers your heaviest axle, and step up to a higher-rated ramp where it does not. For wider openings, join units end to end rather than stretching a single unit.

Installation, use and care

Set the ramp on a clean, dry, flat surface, open the lid, lay each cable into its own channel, then close the lid so it sits flush. Join further units through the interlocking ends to extend the crossing. Keep channels free of grit and debris so cables seat fully and the lid closes, and rinse or wipe the ramp after muddy site use. Store flat and, where you can, out of prolonged direct sunlight to protect the lid over time.

Frequently asked questions

How many cables does it take? Five, one per channel, each channel 50mm x 36mm.

Can vehicles cross it? Yes, up to a stated 6 tonne capacity; confirm your heaviest vehicle is within that figure.

Can I extend it? Yes. Units interlock end to end to bridge wider routes.

Is it for indoor or outdoor use? Both; it is widely used at outdoor events. Store out of prolonged sunlight to extend lid life.

Does it carry a formal slip rating? A formal slip rating is not published for this line; the ramped sides provide an anti-slip tread.

Ordering and delivery

Add the ramp to your basket to see current lead time and delivery options, and order multiple units where you need to join a longer crossing. If you are not sure whether five channels or a higher load rating suits your set-up, contact us before ordering and we will help you match the right unit to the job.